Krone 870 HDP, Оригинальная инструкция по эксплуатации, Страница: 482 / 568

8 Terminal – menus [Medium Plus/Comfort Plus Electronics]
8.15 Menu 15 "Settings"
76
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
Æ
If dimension X=2-3 mm , the sensor has been correctly set.
Æ
If dimension X is not 2-3 mm , set the sensor.
Adjustment
„
Loosen the nuts (5) on both sides of the sensor (4).
„ Turn the nuts (5) until dimension X=2-3 mm .
„
Tighten the nuts (5) (tightening torque = 10 Nm).
„ In the sensor test check whether the sensor (4) is attenuated, refer to page 69 .
Æ
The sensor has been adjusted correctly if the sensor test shows that the sensor is alive.
Æ
If the sensor test shows that the sensor is not alive, adjust the sensor until the sensor test
shows that the sensor is alive.
8.15.2 Menu 15-2 "Actuator test"
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
„
The safety routines must be read and observed to avoid accidents, refer to page 21 .
„
Observe the safety routine "Run actuator test safely", refer to page 22 .
Possible actuators (depending on how the machine is equipped)
An overview of the position of the sensors and actuators is in the circuit diagram, refer to
page 92 .
No. Actuator Designation
K01 K01 Move in pilot valve
K02 K02 Move out pilot valve
K03 K03 Bale chute valve piston side
K04 Y04 Bale chute valve ring side
K05 K05 Residual bale ejector piston side
K06 K06 Residual bale ejector ring side
K07 K07 Blade cassette valve ring side
K08 K08 Blade cassette valve piston side
K09 K09 Open bale channel flaps