Krone 870 HDP, Оригинальная инструкция по эксплуатации, Страница: 481 / 568

Terminal – menus [Medium Plus/Comfort Plus Electronics] 8
Menu 15 "Settings" 8.15
Supplement to Operating Instructions 150000774_00 _en
BiG Pack 870 HDP, BiG Pack 870 HDP XC
75
BP000-245
„
Press a bale (2) until ¾ of its length have exited the bale channel (1).
Æ The signal sheet (3) does not cover the sensor (4). The sensor (4) is unattenuated (there is
no iron in front of the sensor).
ü
The machine is shut down and safeguarded, refer to page 21 .
„ Check dimension X, measured between the upper edge of the sensor (4) and the edge of
the signal sheet (3).
Æ
If dimension X=5 mm , the distance of the sensor is correct.
Æ If dimension X is not 5 mm , adjust the sensor.
Adjustment
„ Loosen the nuts (5) on both sides of the sensor (4).
„
Push the sensor (4) upwards until dimension X=5 mm .
Measured between the upper edge of the sensor (4) and the edge of the signal sheet (3).
„ Tighten the nuts (5) (tightening torque = 10 Nm).
„
In the sensor test check that the sensor (4) is still unattenuated, refer to page 69 .
Æ The sensor has been adjusted correctly if the sensor test shows that the sensor is not alive.
Æ
If the sensor test shows that the sensor is attenuated, adjust the sensor until the sensor test
shows that the sensor is unattenuated.
BP000-246
Check
„
Continue pressing the bale (2) until it has completely left the bale channel (1).
Æ The signal sheet (3) completely covers the sensor (4). The sensor (4) is attenuated (iron).
ü
The machine is shut down and safeguarded, refer to page 21 .
„ Check dimension X, measured between the signal sheet (3) and the sensor (4).