Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 45 / 218

PAT-T 4kW
4-3
4
B
a
s
ic O
p
er
a
ti
on
4.2 Measured Value Display and Setting
Display (Setting the Output Voltage and
Output Current)
The panel display has two modes. One mode displays the measured values of the
output voltage and output current, and the other mode displays the settings. These
two modes can be distinguished by the on/off state of the SET, OVP•OCP, and
CONFIG keys.
• When the phase input mode is changed to the single-phase input mode from the
three-phase input mode, the setting value of the output current and the
overcurrent protection (OCP) is limited to 75 % of the rated value of output
current and the overcurrent protection of the three-phase input mode.
■
Measured value display
The measured value display shows the present output terminal voltage and load
current. In this mode, the LEDs of the SET, OVP•OCP, and CONFIG keys are all
off.
p. 4- 8
You can change the output voltage and current settings in the measured value
display mode.
Fig.4-1 Meas u red val u e display example
■
Setting display
The following three states are available.
• Setting display of the output voltage and output current
Press the SET key. The key LED illuminates. The present output voltage and
current are displayed.
Fig.4-2 Setting display example of the o u tp u t voltage and o u tp u t
c u rrent
p. 4-24
If you save or recall a preset memory, the panel display shows the preset memory
values.
See
EXT EXT
RMT
LOCK
PRESET A
B C
A V
OUTPUT
ALARM
C V
Switch turned off
EXT EXT
RMT
LOCK
PRESET A B C
A V
OUTPUT
ALARM
Lights on
See