Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 30 / 218

2- 8
PAT-T 4kW
(Single-phase input Mode) Connection procedure
Possible electric shock.
When connecting the input power in single-phase input mode, the
voltage around 100 V to 150 V are applied to the U terminal (the
terminal used for the three-phase input mode) on the input terminal
board. When in single-phase input mode, be sure to connect the
power cable to the L terminal and the N terminal, and connect the
ground terminal (GND terminal) to earth ground.
This product does not come with a power cable. Use a three-core PVC insulated
cable with a nominal cross-sectional area of at least 5.5 mm
2
for 600 Vac.
Fig.2-5 Connecting the po w er cable for single-phase inp u t mode
1
Check that the AC po w er s u pply meets the nominal inp u t rating of the
prod u ct.
The voltage that can be applied is any of the nominal power supply voltages in the
range of 200 Vac to 240 Vac. The frequency is 50 Hz or 60 Hz.
2
Check that the POWER s w itch is t u rned off.
3
Connect the po w er cable to the AC I N PUT terminal block as sho w n in
Fig.2-5
4
Attach crimping terminals to the s w itchboard end of the po w er cable.
Attach crimping terminals that comply with the terminal screws on the switchboard
5
T u rn off the s w itchboard breaker.
6
Connect the po w er cable by matching the L, N , and (G N D) terminal
of the s w itchboard.
Connect the power cable firmly so that it does not come loose.
WARNING
GND
(GND)
(GND)
N
L
N
L
AC INPUT terminal b lock
M6 screws
Terminal b lock co v er
Terminal b lock co v er
( Single-phase mode)
* W hen the power ca b le
layout is in re v erse
direction, this terminal
co v er should b e attached in
the up-side down position.
Use this screw hole
(for single-phase mode)