Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 32 / 218

2-10
PAT-T 4kW
Turning the POWER switch on
p. 4-29
If the POWER switch is turned on for the first time after purchasing the PAT, the
PAT starts up in a factory default condition.
1
Check that the po w er cable is correctly connected.
2
Raise the lever and t u rn the POWER s w itch on.
If an odd sound, odd odor, fire, or smoke occurs around or in the PAT, lower the
POWER lever to turn it off.
3
Check the firm w are version on the front panel display.
p. 4-3
The voltmeter and ammeter show the PAT firmware version for approximately 1
second. The measuring value will be shown after the firmware version is displayed.
Fig.2-6 Firm w are version display at po w er-on (example for Ver.4.00)
■
If the error is displayed after turning the power on
If front panel display shows indicated in Table 2-1 after power-on, follow the
corresponding remedy. If the remedy does not correct the problem, contact your
Kikusui agent or distributor.
Table 2-1 Panel display d u ring and after po w er-on
See
See
Panel Display Ca u se and Remedy
SYS1 ERR
The PAT may have malf u nctioned. Contact yo u r
Kik u s u i agent.
SYS2 ERR
The calibration has not been completed normally.
Re-calibrate. If “SYS2 ERR” appears even after re-
calibration, the PAT may have malf
u nctioned. Contact
yo u r Kik u s u i agent.
CLR ABC
Preset memories A, B, and C have been reset to
factory defa
u lt settings beca u se the val u es w ere
abnormal. To contin u e the operation, press any panel
key.
CLR SET
The voltage and c u rrent calibration val u es have been
reset to factory defa u lt settings, beca u se the val u es
w ere abnormal. To contin u e the operation, press any
panel key.
CLR CO N F
The CO N FIG settings have been reset to factory
defa u lt val u es, beca u se the val u es w ere abnormal.To
contin u e the operation, press any panel key.
EXT EXT
RMT
LOCK
PRESET A B C
A V
OUTPUT
ALARM
Indicates the v ersion
Firmware v ersion
A V
A V
A V
A V
A V