Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 71 / 218

PAT-T 4kW
4-29
4
B
a
s
ic O
p
er
a
ti
on
Fig.4-27 On/Off u sing the mechanical s w itch
4.12 Factory Default Settings
Turning ON the POWER switch while holding down the SHIFT key initializes the
settings to factory default. Carry out this operation when you want to reset all
settings to factory default values. The factory default settings are given in the tables
below.
Table 4-2 Factory dfa u lt settings of basic parameters
Table 4-3 Factory defa u lt settings of the CO N FIG parameters
Load
S
+
–
C
+
–
+S
–S
+
–
Basic Item Setting
O u tp u t voltage 0 V
O u tp u t c u rrent 105 % of the rated o u tp u t c u rrent
Overvoltage protection (OVP) 111.5 % of the rated o u tp u t voltage
Overc u rrent protection (OCP) 111.5 % of the rated o u tp u t c u rrent
Preset memory val u es A/B/C Voltage: 0 V, C u rrent: 105 % of the rated o u tp u t c u rrent
Parameter
n u mber
Operating condition
(CO N FIG parameter)
Setting
CF10 O u tp u t on delay setting OFF
CF11 O u tp u t off delay setting OFF
CF12 Preset recall setting w hile locked 1 ( u nable to recall)
CF13 Comm u nication error display setting OFF (not displayed)
CF20 CV control so u rce setting 0 (panel control)
CF21 CC control so u rce setting 0 (panel control)
CF22 External control logic setting of the
o
u tp u t on/off
H
CF23 Stat u s signal setting of the po w er on/off 0 (POWER O N STATUS)
CF24 Setting the n u mber of u nits in Master-
Slave Parallel Operation
1 (1 u nit)
CF25 O u tp u t stat u s setting at po w er-on OFF (o u tp u t off at po w er-on)
CF26 Master-slave parallel setting 0 (master u nit)
CF27 Breaker trip setting w hen the sh u tdo w n
signal is applied
OFF (not trip)