Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 111 / 218

PAT-T 4KW
7-5
7
Remot
e
Cont
ro
l
Protocol
Table 7-1 shows the RS232C protocol. Underline indicates factory default
condition. The value inside the parentheses is the CONFIG setting value.
Table 7-1 RS232C protocol
Break signal
The break signal functions as a substitute for the IEEE488.1 dcl/sdc (Device Clear,
Selected Device Clear) message.
RS232C communication
Use flow control for RS232C communication. DC (device control) codes are used
as control codes.
Transmission/reception may not work correctly through unilateral transmission.
Table 7-2 DC codes
Fig.7-2 RS232C terminal and transmission control of the PAT
Item Setting
Connector 9-pin D-s u b terminal on the rear panel
Ba u drate 1 200 bps/ 2 400 bps/ 4 8 00 bps/ 9 600 bps/ 19 200 bps/ 3 8 400 bps
(1.2/2.4/4. 8 /9.6/19.2/3 8 .4)
Data length ( 8 bits or 7 bits)
Stop bit (1 bit or 2 bits)
Parity Fixed to none
Flo w (X-flo w control) XFLOW / N one (on/off)
Code F u nction ASCII code
DC1 (Xon) Req u est to send 11H
DC3 (Xoff) Transmission stop req u est 13H
Resume transmission
DC3 TXD
RXD
The RS232C terminal must pause transmission
within 10 characters after recei
v ing DC3.
W ithin 10
characters
DC1
Pause
PAT