Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 144 / 218

7-3 8
PAT-T 4KW
INIT:SEQ3 / INIT:NAME ACQ
Clears the present valid measurement data and starts a new measurement.
If the trigger source parameter of the sequence 3 group is IMM, the measurement
starts immediately. If set to BUS, the measurement starts after waiting for a
software trigger.
New measurement data will be established after 4 ms from the measurement begins.
The measured data is stored in the measurement data cache, and it can be queried by
"FETC:xxx?"command. The measurement data returns the mean value data (the
moving average deviations of 64 times measured in every 4 ms).
Command
INITiate[:IMMediate]:SEQuence3
INITiate[:IMMediate]:NAME ACQuire
TRIG:SEQ3 / TRIG:ACQ
Executes a software trigger to the sequence 3 group.
Command
TRIGger:SEQuence3[:IMMediate]
TRIGger:ACQuire[:IMMediate]
Sequence operation auto continue mode
When the sequence operation auto continue mode is turned on
If the trigger source parameter is set to IMM, the measurement starts
immediately. When the operation is complete, a new measurement automatically
starts.
If the parameter is set to BUS, the measurement starts after receiving a software
trigger. When the operation is complete, the PAT waits for the next trigger.
When the sequence operation auto continue mode is turned off
The measurement currently in progress continues unless ABOR is sent. New
measurements are not automatically continued.
INIT:CONT:SEQ3 / INIT:CONT:NAME ACQ
Sets the measurement conditions of the sequence 3 group in sequence operation
auto continue mode.
Command
INITiate:CONTinuous:SEQuence3 {ON|OFF|1|0}
INITiate:CONTinuous:SEQuence3?
INITiate:CONTinuous:NAME ACQuire,{ON|OFF|1|0}
INITiate:CONTinuous:NAME? ACQuire