HP E4510-48G, Справочник по командам

Страница: 976 / 1334

1-27
Description
Use the user privilege level command to configure the command level available to the users logging
into the user interface.
Use the undo user privilege level command to revert to the default command level.
By default, the commands of level 3 are available to the users logging into the AUX user interface. The
commands of level 0 are available to the users logging into VTY user interfaces.
Commands fall into four command levels: visit, monitor, system, and manage, which are described as
follows:
z
Visit level: Commands of this level are used to diagnose network and change the language mode
of user interface, such as the ping , tracert . The Telnet command is also of this level. Commands
of this level cannot be saved in configuration files.
z
Monitor level: Commands of this level are used to maintain the system, to debug service problems,
and so on. The display and debugging command are of monitor level. Commands of this level
cannot be saved in configuration files.
z
System level: Commands of this level are used to configure services. Commands concerning
routing and network layers are of system level. You can utilize network services by using these
commands.
z
Manage level: Commands of this level are for the operation of the entire system and the system
supporting modules. Services are supported by these commands. Commands concerning file
system, file transfer protocol (FTP), trivial file transfer protocol (TFTP), downloading using
XModem, user management, and level setting are of administration level.
Examples
# Configure that commands of level 0 are available to the users logging into VTY 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 0
# You can verify the above configuration by Telnetting to VTY 0 and displaying the available
commands, as listed in the following.
<Sysname> ?
User view commands:
ping Ping function
quit Exit from current command view
super Set the current user priority level
telnet Establish one TELNET connection
tracert Trace route function
undo Undo a command or set to its default status