HP E4510-48G, Справочник по командам

Страница: 134 / 1334

4-22
Default Level
2: System level
Parameters
enable : Configures the current port(s) to be an edge port or edge ports.
disable : Configures the current port(s) to be a non-edge port or non-edge ports.
Description
Use the stp edged-port enable command to configure the port(s) as an edge port or ports.
Use the undo stp edged-port command to restore the default.
All ports are non-edge ports by default.
Note that:
z
Configured in Ethernet interface view, the setting takes effect on the current interface only;
configured in port group view, the setting takes effect on all ports in the port group.
z
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate
interface; configured on a member port in an aggregation group, the setting can take effect only
after the port leaves the aggregation group.
z
If a port directly connects to a user terminal rather than another device or a shared LAN segment,
this port is regarded as an edge port. When the network topology changes, an edge port will not
cause a temporary loop. Therefore, configuring a port as an edge port can enable the port to
transition to the forwarding state rapidly. We recommend that you configure a port directly
connecting to a user terminal as an edge port to enable it to transition to the forwarding state
rapidly.
z
Normally, configuration BPDUs from other devices cannot reach an edge port because it does not
connect to any other device. Before the BPDU guard function is enabled, if a port receives a
configuration BPDU, the port is working actually as a non-edge port even if you have configured it
as an edge port.
Examples
# Configure GigabitEthernet 1/0/1 as an edge port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp edged-port enable
stp enable
Syntax
stp enable
undo stp enable
View
System view, Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level