HP E4510-48G, Справочник по командам

Страница: 923 / 1334

6-9
Use the undo cfd mep enable command to disable the MEP.
By default, MEP is disabled on a port and cannot respond to LTM and LBM messages unless you
enable it.
Related commands: cfd mep .
Examples
# Enable MEP 3 in service instance 5.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] cfd mep service-instance 5 mep 3 enable
cfd mip-rule
Syntax
cfd mip-rule { explicit | default } service-instance instance-id
undo cfd mip-rule service-instance instance-id
View
System view
Default level
2: System level
Parameters
service-instance instance-id : Specifies the service instance ID, ranging from 1 to 32767.
explicit : This rule means that if the lower level MA is not configured with MIPs, whether the current MA
will create MIPs depends on whether the lower level MA is configured with MEPs.
default : This rule means that if the lower level MA is not configured with MIPs, the current MA will
create MIPs.
Description
Use the cfd mip-rule command to configure the rule for generating MIPs.
Use the undo cfd mip-rule command to delete the rule for generating MIPs.
By default, no rules for generating MIPs are configured, nor are the MIPs themselves.
MIPs are generated on each port automatically according to the rules configured. If a port has no MIP,
the system will check the MAs in each MD (from low to high level), and follow the rules in Table 6-4 to
create or not create MIPs (within a single VLAN):