HP E4510-48G, Справочник по командам

Страница: 73 / 1334

1-19
Default Level
2: System level
Parameters
.None
Description
Use the jumboframe enable command to allow jumbo frames with the length of 9216 bytes to pass
through an Ethernet port.
Use the undo jumboframe enable command to prevent frames longer than 1522 bytes from passing
through an Ethernet port.
By default, the device allows frames no larger than 9216 bytes to pass through an Ethernet port.
You can configure length of jumbo frames on a port (in Ethernet port view, port-group view) to allow
them to pass through Ethernet ports.
z
Execution of this command under Ethernet port view will only apply the configurations to the
current Ethernet port.
z
Execution of this command under port group view will apply the configurations to the Ethernet
port(s) in the port group.
Examples
# Enable jumbo frames to pass through all the Ethernet ports in the manual port group named group1 .
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member GigabitEthernet 1/0/1
[Sysname-port-group-manual-group1] jumboframe enable
# Enable jumbo frames to pass through GigabitEthernet1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] jumboframe enable
link-delay
Syntax
link-delay delay-time
undo link-delay
View
Ethernet port view
Default Level
2: System level
Parameters
delay-time : Up/down suppression time for the physical connection of an Ethernet port (in seconds). in
the range 2 to 10.