HP E4510-48G, Справочник по командам

Страница: 241 / 1334

11-2
Use the undo bpdu-tunnel dot1q command to disable BPDU tunneling for a protocol on the port or
ports.
By default, BPDU tunneling for any protocol is disabled.
Note that:
z
Settings made in Ethernet interface view or Layer 2 aggregate interface view take effect only on
the current port; settings made in port group view take effect on all ports in the port group.
z
You cannot enable BPDU tunneling on a member port of a service loopback group.
z
Before enabling BPDU tunneling for DLDP, EOAM, GVRP, HGMP, LLDP, or STP on a port,
disable the protocol on the port first. Because PVST is a special STP protocol, before enabling
BPDU tunneling for PVST on a port, you need to disable STP and then enable BPDU tunneling for
STP on the port first.
z
Before enabling BPDU tunneling for LACP on a dynamic aggregation group member port, remove
the port from the dynamic aggregation group first.
Examples
# Disable STP on GigabitEthernet1/0/1, and then enable BPDU tunneling for STP on the port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
[Sysname-GigabitEthernet1/0/1] bpdu-tunnel dot1q stp
# Disable STP for port group 1, and then enable BPDU tunneling for STP on all the ports in the port
group.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet 1/0/6
[Sysname-port-group-manual-1] undo stp enable
[Sysname-port-group-manual-1] bpdu-tunnel dot1q stp
# Disable STP on Layer 2 aggregate interface 1, and then enable BPDU tunneling for STP on the port.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] undo stp enable
[Sysname-Bridge-Aggregation1] bpdu-tunnel dot1q stp
bpdu-tunnel tunnel-dmac
Syntax
bpdu-tunnel tunnel-dmac mac - address
undo bpdu-tunnel tunnel-dmac
View
System view
Default Level
2: System level