HP E4510-48G, Справочник по командам

Страница: 1233 / 1334

18-25
Use the undo probe count command to restore the default.
By default, one probe is performed in an NQA test.
z
For a TCP or DLSw test, one probe means one connection;
z
For a UDP jitter test or a voice test, the number of packets sent in one probe depends on the
probe packet-number command;
z
For an FTP, HTTP or DHCP test, one probe means to carry out a corresponding function;
z
For an ICMP echo or UDP echo test, one packet is sent in one probe;
z
For an SNMP test, three packets are sent in a probe.
If the number of probes in a test is greater than 1, the system performs a second probe after it
performs the first probe and receives a response packet. If the system does not receive a response
packet, it waits for the test timer to expire before performing a second probe. The process is repeated
until the specified probes are completed.
Note that this command is not supported in a voice test. Only one probe can be made in a voice test.
Examples
# Configure the number of probes in an ICMP echo test as 10.
<Sysname> system-view
[Sysname] nqa entry admin-test
[Sysname-nqa-admin-test] type icmp-echo
[Syaname-nqa-admin-test-icmp-echo] probe count 10
probe packet-interval
Syntax
probe packet-interval packet-interval
undo probe packet-interval
View
UDP jitter, voice test type view
Default Level
2: System level
Parameters
packet-interval : Interval for packets sent in a probe in a test, in milliseconds, in the range 10 to 60000.
Description
Use the probe packet-interval command to configure the interval for sending packets in a probe in a
test.
Use the undo probe-interval command to restore the default.
By default, the interval is 20 milliseconds.
Examples
# Configure the interval for sending packets in a probe in a UDP jitter test as 100 milliseconds.
<Sysname> system-view