HP E4510-48G, Справочник по командам

Страница: 179 / 1334

5-26
inventory : Sends hardware revision TLVs, firmware revision TLVs, software revision TLVs, serial
number TLVs, manufacturer name TLVs, model name TLVs, and asset ID TLVs.
location-id : Sends location identification TLVS.
civic-address : Inserts the address information about the intermediate device in location identification
TLVs .
device-type : Device type value. A value of 0 specifies DHCP server; a value of 1 specifies switch, and
a value of 2 specifies LLDP-MED endpoint.
country-code : Country code, confirming to ISO 3166.
{ ca-type ca-value }&<1-10>: Configures address information, where ca-type represents the address
information type, in the range 0 to 255, ca-value represents address information, a string of 1 to 250
characters, and &<1-10> indicates that you can enter up to ten such parameters.
elin-address : Inserts telephone numbers for urgencies in location identification TLVs.
tel-number : Telephone number for urgencies, a string of 10 to 25 characters.
network-policy : Sends network policy TLVs.
power-over-ethernet : Sends extended power-via-MDI TLVs.
Description
Use the lldp tlv-enable command to configure advertisable TLVs for a port or all the ports in a port
group.
Use the undo lldp tlv-enable command to disable the sending of specific TLVs.
By default, all the TLVs except location identification TLVs are advertisable on a port.
Note that:
z
To enable MED related LLDP TLV sending, you need to enable LLDP-MED capabilities TLV
sending first. Conversely, to disable LLDP-MED capabilities TLV sending, you need to disable the
sending of other MED related LLDP TLV.
z
To disable MAC/PHY configuration/status TLV sending, you need to disable LLDP-MED
capabilities TLV sending first.
z
Enabling the sending of LLDP-MED capabilities TLVs also enables the sending of MAC/PHY
configuration/status TLVs.
z
You can specify to send multiple types of TLVs by executing the lldp tlv-enable command
repeatedly.
Examples
# Enable the sending of link aggregation group TLVs of the IEEE 802.3 organizationally specific TLVs
on GigabitEthernet1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp tlv-enable dot3-tlv link-aggregation