HP E4510-48G, Справочник по командам

Страница: 248 / 1334

12-6
z
The destination mirroring port can be an access, trunk, or hybrid port. It must be assigned to the
remote mirroring VLAN.
z
A remote source port mirroring group cannot contain destination ports.
z
Before configuring the destination port for a port mirroring group, make sure the port mirroring
group exists.
z
Do not enable STP, RSTP, or MSTP on the destination port. Otherwise, the mirroring function
may be affected.
z
Do not use the destination mirroring port for any purpose other than port mirroring.
Examples
# Configure GigabitEthernet 1/0/1 as the monitor port in remote destination mirroring group 1.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-destination
[Sysname] mirroring-group 1 monitor-port GigabitEthernet 1/0/1
mirroring-group remote-probe vlan
Syntax
mirroring-group groupid remote-probe vlan rprobe-vlan-id
undo mirroring-group groupid remote-probe vlan rprobe-vlan-id
View
System view
Default Level
2: System level
Parameters
groupid : Number of a remote source or destination mirroring group, in the range of 1 to 4.
rprobe-vlan-id : ID of the VLAN to be configured as the remote probe VLAN. This VLAN must be a static
VLAN that already exists.
Description
Use the mirroring-group remote-probe vlan command to specify a VLAN as the remote probe VLAN
for a remote source or destination mirroring group.
Use the undo mirroring-group remote-probe vlan command to remove the remote probe VLAN
from the remote source or destination mirroring group.
Note that:
z
Only remote source port mirroring groups or remote destination port mirroring groups can have
remote mirroring VLANs. A port mirroring group can have only one remote mirroring VLAN.
z
To remove a VLAN operating as a remote port mirroring VLAN, you need to restore it to a normal
VLAN first. A remote port mirroring group gets invalid if the corresponding remote port mirroring
VLAN is removed.
z
You are recommended to use a remote mirroring VLAN for remote mirroring only.