HP E4510-48G, Справочник по командам

Страница: 250 / 1334

12-8
monitor-port
Syntax
[ mirroring-group groupid ] monitor-port
undo [ mirroring-group groupid ] monitor-port
View
Ethernet port view
Default Level
2: System level
Parameters
groupid : Number of a local or remote destination mirroring group, in the range of 1 to 4.
Description
Use the monitor-port command to assign the current port to a local or remote destination mirroring
group as the monitor port.
Use the undo monitor-port command to remove the current port from the mirroring group.
When assigning a port to a mirroring group as the monitor port, note that:
z
If no mirroring group is specified, the port is assigned to port mirroring group 1.
z
The port cannot belong to any other mirroring group.
z
Whether you assign the port to port mirroring group 1 or any other mirroring group, ensure that the
mirroring group already exists.
z
The remote destination mirroring port can be an access, trunk, or hybrid port. It must be assigned
to the remote mirroring VLAN.
z
Do not enable STP, RSTP, or MSTP on the destination port. Otherwise, the mirroring function
may be affected.
z
Do not use the destination mirroring port for any purpose other than port mirroring.
Examples
# Configure GigabitEthernet 1/0/1 as the monitor port in local mirroring group numbered 1.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] monitor-port