Error solving manual.
CNC 8060
CNC 8065
·29·
(R
EF
: 1709)
1127
'The $FOR instruction<condition> instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1128
'$FOR: too many characters in the condition'
DETECTION
During execution.
CAUSE
The block that contains the $FOR instruction has more than 5100 characters.
SOLUTION
Write the block that contains the $FOR instruction shorter.
1129
'$ENDFOR not expected'
DETECTION
During execution.
CAUSE
The CNC has detected an $ENDFOR instruction without a previous $FOR
instruction.
SOLUTION
Check the program.
1130
'The $ENDFOR instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1131
'The $WHILE <condition> instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1132
'$WHILE: too many characters in the condition'
DETECTION
During execution.
CAUSE
The condition of the $WHILE instruction exceeds the maximum number of characters
allowed.
SOLUTION
The maximum number of characters allowed is 5000.
1133
'$ENDWHILE not expected'
DETECTION
During execution.
CAUSE
The CNC has detected an $ENDWHILE instruction without a previous $WHILE
instruction.
SOLUTION
Check the program.
1134
'The $ENDWHILE instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1135
'The $DO instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1136
'$ENDDO not expected'
DETECTION
During execution.
CAUSE
The CNC has detected an $ENDDO instruction without a previous $DO instruction.
SOLUTION
Check the program.
1137
'The $ENDDO <expression> instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1138
'The $BREAK instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
Содержание 8065
