Fagor 8065, Руководство по устранению ошибок

Страница: 94 / 220

Error solving manual.
CNC 8060
CNC 8065
·94·
(R
EF
: 1709)
1876 'Pocket with islands: Wrong XY profile'
DETECTION During the execution of the cycle.
CAUSE Geometry of the surface profile programmed wrong.
SOLUTION Correct the geometry of the profile from the profile editor.
1877 'Pocket with islands: Z profile does not exist'
DETECTION During the execution of the cycle.
CAUSE The programmed depth profile does not exist.
SOLUTION Select an existing profile or generate the programmed profile.
1878 'Pocket with islands: Wrong finishing tool tip (nose) radius'
DETECTION During the execution of the cycle.
CAUSE The tip radius (Rp) of the finishing tool is greater than its radius ( R ).
SOLUTION Correct the tool tip (nose) radius.
1879 'Pocket with islands: Wrong semi-finishing tool radius'
DETECTION During the execution of the cycle.
CAUSE The semi-finishing tool radius 0 or it is too large for the geometry of the pocket.
SOLUTION Correct the tool in the table or select another tool.
1880 'Pocket with islands: Semi-finishing T missing'
DETECTION During the execution of the cycle.
CAUSE The programmed tool does not exist in the tool table.
SOLUTION Correct the tool in the table or select another tool.
1881 'Pocket with islands: Wrong semi-finishing F'
DETECTION During the execution of the cycle.
CAUSE The semi-finishing feedrate is 0.
SOLUTION Define a feedrate higher than 0.
1882 'Pocket with islands: Wrong semi-finishing S'
DETECTION During the execution of the cycle.
CAUSE The spindle speed for the semi-finishing operation is 0.
SOLUTION Define a speed higher than 0.
1883 'Pocket with islands: Pocket already in execution'
DETECTION During the execution of the cycle.
CAUSE The CNC cannot simulate or execute the pocket because it is already in execution
or simulation.
SOLUTION Wait for the CNC to finish the simulation or execution.
1884 'Pocket with islands: Arc programmed wrong in the profile'
DETECTION During the execution of the cycle.
CAUSE In some profile of the pocket, there is an arc that has been defined wrong or the profile
has been modified with a program other than the profile editor.
SOLUTION Correct the geometry of the profile from the profile editor.
1885 'Pocket with islands: Wrong pocket geometry'
DETECTION During the execution of the cycle.
CAUSE In some profile of the pocket, there is a section that has been defined wrong (rounding,
chamfer, etc.).
SOLUTION Correct the geometry of the profile from the profile editor.
1886 'Pocket with islands: Wrong roughing tool's penetration angle'
DETECTION During the execution of the cycle.
CAUSE The roughing penetration angle (parameter

) is not between 0º and 90º.
SOLUTION Correct the penetration angle; program a value between 0º and 90º.
1887 'Pocket with islands: Wrong penetration angle of the semi-finishing tool'
DETECTION During the execution of the cycle.
CAUSE The finishing penetration angle (parameter

) is not between 0º and 90º.
SOLUTION Correct the penetration angle; program a value between 0º and 90º.