Fagor 8065, Руководство по устранению ошибок

Страница: 114 / 220

Error solving manual.
CNC 8060
CNC 8065
·114·
(R
EF
: 1709)
2370 Thread axis non-existent.
DETECTION During execution.
CAUSE The thread axis is defined by the letter used to program the leadscrew pitch for the
block. The programmed axis does not exist.
SOLUTION Program the leadscrew pitch for a valid axis.
2371 #LSFIT, algorithm does not converge, check the input data.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2372 #LSFIT, maximum amount of data exceeded.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2373 #LSFIT, insufficient amount of data.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2374 #LSFIT, calculation error (radius=0), check input data.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2375 #LSFIT, calculation error (SVD), check input data.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2376 #LSFIT, calculation error (SVBK), check input data.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2377 #LSFIT, the instruction is invalid.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2378 #GAPCTRL: The axis or GAP needs to be programmed.
DETECTION During execution.
CAUSE For the command #GAPCTRL, the axis or gap has not been programmed.
SOLUTION Program the axis and/or the GAP.
2379 #GAPCTRL: Machine parameter GAPANAINID is zero or unassigned.
DETECTION During execution.
CAUSE The analog input to which the gap sensor is associated (parameter GAPANAINID)
has not been defined.
SOLUTION Assign the correct value to the machine parameter GAPANAINID.
2380 #LSFIT, internal error.
DETECTION During execution.
CAUSE Error with the kinematics calibration cycle.
SOLUTION Contact Fagor.
2381 #ABORT OFF not programmed in the same subroutine as #ABORT.
DETECTION During execution.
CAUSE The command #ABORT OFF is not programmed. If the command #ABORT is only
programmed in the block, when aborting the program, the execution continues for
the command #ABORT OFF.
SOLUTION Program #ABORT OFF.