Fagor 8065, Руководство по устранению ошибок

Страница: 165 / 220

Error solving manual.
CNC 8060
CNC 8065
·165·
(R
EF
: 1709)
7023 'In load mode: M6 mandatory'
DETECTION During execution.
CAUSE Magazine in load mode. Two consecutive tools have been programmed without M06.
SOLUTION Program M06 after each tool.
7024 'In unload mode: T0 not admitted'
DETECTION During execution.
CAUSE Magazine in unload mode. T0 cannot be programmed.
SOLUTION Program the tool to be unloaded into the magazine.
7025 'In unload mode: M6 mandatory'
DETECTION During execution.
CAUSE Magazine in unload mode. Two consecutive tools have been programmed without
M06.
SOLUTION Program M06 after each tool.
7026 'In unload mode: This tool is already unloaded'
DETECTION During execution.
CAUSE Magazine in unload mode. The tool is not in the magazine.
SOLUTION Program the tool to be unloaded into the magazine.
7027 'M6 without T'
DETECTION During execution.
CAUSE An M06 has been programmed without its corresponding tool. There is a machine
parameter that indicates to the CNC what to do in this situation, show an error, a
warning or do nothing.
SOLUTION Program a tool and then the M06 function or change the machine parameter to
change the behavior of the CNC.
7028 'T0 not admitted'
DETECTION During execution.
CAUSE T0 not allowed in a turret type magazine. In a turret type magazine, the tool change
is done by rotating the turret; it is enough to program the tool.
SOLUTION It cannot be programmed like this.
7029 'The operation cannot be carried out: Error at the tool manager'
DETECTION During execution.
CAUSE Magazine in emergency state. The PLC has activated an invalid mark of the
maneuver, the PLC has activated the SETTMEM mark or there is an error in the
maneuver.
SOLUTION Correct the tool change maneuver in the PLC program. If the PLC has activated the
SETTMEM mark, check why the PLC has set the emergency signal.
7030 'M6 without T'
DETECTION During execution.
CAUSE An M06 has been programmed without its corresponding tool. There is a machine
parameter that indicates to the CNC what to do in this situation, show an error, a
warning or do nothing.
SOLUTION Program a tool and then the M6 function or change the machine parameter to change
the behavior of the CNC.
7031 'T with two M6'
DETECTION During execution.
CAUSE Two consecutive M06 have been programmed for the same tool.
SOLUTION Program one M06 for each tool.
7032 'Error in the PLC operation'
DETECTION During execution.
CAUSE Wrong sequence in the PLC program.
SOLUTION Check the PLC program.