Fagor 8065, Руководство по устранению ошибок

Страница: 137 / 220

Error solving manual.
CNC 8060
CNC 8065
·137·
(R
EF
: 1709)
3730 'TOUCHPROBE: The selected flank will be ignored because it is different from the active
one'
DETECTION When the PLC is executing a TOUCHPROBE command.
CAUSE The PLC has tried to execute a probing action, but the probe is being used by a
previous TOUCHPROBE command or both commands use different flanks.
SOLUTION In simultaneous probing operations on different axes, either the same probing flank
must be used or the probing operations must be carried out with different probes.
3731 'G174: Invalid movement, value too high'
DETECTION When executing G174
CAUSE When calculating the movement programmed in units of the drive, the resulting value
is out of the range allowed by the drive.
SOLUTION Change value programmed in G174.
3734 'PWM software option not allowed'
DETECTION During CNC startup.
CAUSE The software option for the PWM feature is not active at the CNC.
SOLUTION Purchse the corresponding option.
3735 'Error when turning the PWM ON/OFF'
DETECTION During laser cutting (PWM).
CAUSE The PWM parameters are set wrong.
SOLUTION Check the following conditions:
• The value of parameter NLOCOUT must be 8.
• The value of parameter PWMOUTPUT must not be higher than 2 (1, 2).
3736 'Machine parameter PWMOUTPUT = 0'
DETECTION During laser cutting (PWM).
CAUSE The value of parameter PWMOUTPUT cannot be 0.
SOLUTION Set the value of parameter PWMOUTPUT within the range (1-2).
3737 'Expansion board not compatible with PWM'
DETECTION During laser cutting (PWM).
CAUSE The hardware is not ready for the PWM feature.
SOLUTION Verify that there is a Sercos type expansion board with the first 2 local outputs ready
for fast switching. The software ID of the FPGA expansion must be equal to or higher
than 1.3, and its hardware ID equal to or higher than 1.2.
3738 'The axis has moved while the CNC was off'
DETECTION During CNC startup.
CAUSE The absolute coordinate (position value) of the drive does not match the one saved
in the last CNC session. The axis has moved more than what was set in parameter
MAXDIFREF.
SOLUTION Verify that the axis position is correct.
3744 #GAPCTRL: No probe signal.
DETECTION During execution.
CAUSE There is no signal from the sensor, which the CNC uses to calculate the distance.
SOLUTION Check the pr obe connections and probe related machine parameters
(GAPANAINTYPE and GAPAANAINID).
3745 The probe has collided.
DETECTION During execution.
CAUSE The PLC has indicated, by using the mark GAPCOLLISION, there has been a
collision with the sensor.
SOLUTION To avoid a collision with the plate, reduce the feedrate. If the error continues, the OEM
will have to modify the machine parameter GAPCOLLISIONMODE.
3800 'Continuous jog feedrate equal to zero'
DETECTION During execution or when changing to continuous jog mode.
CAUSE The feedrate for continuous jog is zero. No jogging feedrate V.G.FMAN has been
programmed and machine parameter JOGFEED is zero.
SOLUTION Set a new feedrate from JOG mode. Check axis machine parameter JOGFEED.