Fagor 8065, Руководство по устранению ошибок

Страница: 39 / 220

Error solving manual.
CNC 8060
CNC 8065
·39·
(R
EF
: 1709)
1255 'Negative acceleration percentage'
DETECTION During execution.
CAUSE In function G130, the programmed percentage of acceleration is negative.
SOLUTION The percentage of acceleration must be equal to or greater than zero.
1256 'Acceleration percentage out of range'
DETECTION During execution.
CAUSE In function G130, the programmed percentage of acceleration is too high.
SOLUTION Check the program.
1257 'The leadscrew pitch has been programmed twice'
DETECTION During execution.
CAUSE In function G33, the thread pitch has been programmed more than once.
SOLUTION Check the program. Define the thread pitch only once in the block.
1258 'Leadscrew pitch equal to zero'
DETECTION During execution.
CAUSE In function G33, the thread pitch is zero.
SOLUTION Check the program. Program the thread pitch with parameters I J K.
1259 'Leadscrew pitch out of range'
DETECTION During execution.
CAUSE In function G33, the programmed thread pitch is too large.
SOLUTION Check the program.
1261 'Unknown kinematics type'
DETECTION During execution.
CAUSE The CNC has tried to activate function #RTCP or #TLC, or a coordinate
transformation (#CS/ACS) in mode 6 without having a kinematics active.
SOLUTION First activate the kinematics and then the desired function.
1262 'The group of the axes is not enough for the transformation'
DETECTION During execution.
CAUSE The channel does not have enough axes to activate function RTCP, TLC or the
coordinate transformation. The number of axes required will depend on the
kinematics to be activated.
SOLUTION Correct the configuration of the axes of the channel (instruction: #SET AX) in order
to be able to activate the kinematics.
1263 'Rotary axis (axes) missing for the transformation'
DETECTION During execution.
CAUSE An instruction #TOOL ORI has been programmed, but there is no rotary axis to place
the tool perpendicular to the defined inclined plane.
SOLUTION Either do not program the instruction #TOOL ORI or activate the kinematics that
allows placing the tool perpendicular to the defined inclined plane.
1264 'Programming not allowed while CS/ACS is active'
DETECTION During execution.
CAUSE The CNC does not allow executing the programmed function if coordinate
transformation is active. Some incompatible functions are G74, G198, G199, #LINK,
probing cycles, etc.
SOLUTION Cancel coordinate transformation to execute the rest of the functions.
1265 'Programming not allowed while RTCP/TLC is active'
DETECTION During execution.
CAUSE The CNC does not allow executing the programmed function if function RTCP or TLC
is active. Some incompatible functions are G74, G198, G199, #KIN ID.
LINK.
SOLUTION Cancel the RTCP or TLC function to execute the rest of the functions.