Fagor 8065, Руководство по устранению ошибок

Страница: 107 / 220

Error solving manual.
CNC 8060
CNC 8065
·107·
(R
EF
: 1709)
2142 'Programming not allowed with Hirth axis (axes)'
DETECTION During execution.
CAUSE A command has been programmed that is incompatible with a Hirth axis.
SOLUTION Check the program.
2143 'The tangent to the spline cannot be calculated'
DETECTION During execution.
CAUSE 'The tangent to unselect the spline cannot be calculated'
SOLUTION Unselect the spline in another point or program another tangent.
2144 'Error when generating the spline'
DETECTION During execution.
CAUSE The first block has not been programmed to activate the spline.
SOLUTION Program a movement before activating the spline.
2145 'End of the program without canceling splines'
DETECTION During execution.
CAUSE The CNC has reached the end of the program while the spline mode is active.
SOLUTION Cancel the spline before finishing the program.
2146 'The spline cannot be canceled'
DETECTION During execution.
CAUSE Not enough blocks to cancel the spline.
SOLUTION Do not program the spline to execute a single block.
2147 'Splines cannot be programmed in HSC mode'
DETECTION During execution.
CAUSE The spline cannot be activated while the HSC mode is active.
SOLUTION Cancel the HSC mode before activating the spline mode.
2148 'Too many motionless blocks between blocks in spline mode'
DETECTION During execution.
CAUSE While the spline mode is active, there are too many motionless blocks (parameter
assignments P, variables, etc.) between two motion blocks.
SOLUTION Reduce the number of motionless blocks programmed; for example, group several
of these blocks into a single block.
2149 'Internal error in tangential control'
DETECTION During execution.
CAUSE Tangential control is not possible.
SOLUTION Eliminate the block that caused the error. Contact Fagor.
2150 'WARNING: #TANGCTRL Additional block between two polynomials'
DETECTION During execution.
CAUSE The CNC inserts an additional positioning block for the tangential axis between two
polynomials.
SOLUTION Contact Fagor.
2151 'Incompatible spline and tangential control have been programmed'
DETECTION During execution.
CAUSE Tangential control cannot be activated while the splines mode is active and vice versa.
SOLUTION Do not program splines while tangential control is active.
2152 'Unreachable theoretical position in the FACE because the tool is out of alignment.
DETECTION During execution.
CAUSE The C axis cannot reach the position because the tool is misaligned with respect to
the turning axis.
SOLUTION Change the machining path or work with tool alignment.
2153 'Helical path near the rotation center of the FACE'
DETECTION During execution.
CAUSE A helical tool path of more than one turn has been programmed for an area close to
the turning center of the FACE.
SOLUTION Change the machining tool path.