Fagor 8065, Руководство по устранению ошибок

Страница: 72 / 220

Error solving manual.
CNC 8060
CNC 8065
·72·
(R
EF
: 1709)
1626 'Program axis for #TANGCTRL ON/OFF/SUSP/RESUME'
DETECTION During execution.
CAUSE The axis or axes are missing in the instruction.
SOLUTION Check the program.
1627 '#TANGCTRL: program angle values between 0 and ±359.9999'
DETECTION During execution.
CAUSE The angle programmed in the instruction is wrong.
SOLUTION Check the program. The angle value must be between 0 and ±359.9999.
1628 'An axis cannot be eliminated from the configuration while tangential control is active'
DETECTION During execution.
CAUSE The CNC cannot eliminate the tangential axis from the configuration if tangential
control is active.
SOLUTION Cancel the tangential control to eliminate this axis from the configuration.
1629 'Only one axis can be programmed in tangential control'
DETECTION During execution.
CAUSE Tangential control being active, a movement or another operation has been
programmed for the tangential axis.
SOLUTION Tangential control being active, it is not possible to program movements of the
tangential axis; it is up to the CNC to orient this axis. To use this axis, cancel the
tangential control.
1630 'The profile has been programmed wrong with labels'
DETECTION During execution.
CAUSE In the call to the cycle, the parameters that define the beginning and end of the profile
(parameters S and E) have been defined wrong.
SOLUTION Assign the correct values to parameters S and E.
1631 'Profile programming not allowed' [S,E,<Q>] or [P,<Q>]'
DETECTION During execution.
CAUSE In the call to the cycle, the parameters that define the beginning and end of the profile
(parameters S and E), the subroutine that contains the profile (parameter P) or the
file that contains the profile (parameter Q) have been defined wrong.
SOLUTION Check the program.
1632 'An axis in active tangential control must be rotary with 360º module'
DETECTION During execution.
CAUSE The CNC has tried to activate the tangential control on a rotary axis with a module
other than 360º.
SOLUTION Tangential control can only be activated on rotary axes with 360º module. The upper
limit of the module is determined by parameter MODUPLIM and the lower limit by
parameter MODLOWLIM.
1633 'Program: #DGSPSL <spindle name>'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong or there is more data in the block.
SOLUTION Check the program.
1634 'The #MOVE instruction only admits one axis and it must belong to the channel'
DETECTION During execution.
CAUSE The programmed axis name is wrong, the axis is in another channel or it is an axis
of the system. Spindles cannot be programmed except when they are working as C
axis, in which case, they must be programmed with the name of the C axis.
SOLUTION Check the program.
1635 'There are too many axes in the transformation'
DETECTION During execution.
CAUSE There are more axes defined in parameter NKINAX of the coordinate transformation
than allowed at the CNC.
SOLUTION Correct machine parameter NKINAX.