Fagor 8065, Руководство по устранению ошибок

Страница: 67 / 220

Error solving manual.
CNC 8060
CNC 8065
·67·
(R
EF
: 1709)
1575 'Instruction only valid in programs with extension FBS'
DETECTION During execution.
CAUSE Programming of instruction #SPLINE or #BSPLINE.
SOLUTION These instructions are only valid in programs with extension fbs'
1576 '"]"not expected'
DETECTION During execution.
CAUSE Syntax error in the instruction.
SOLUTION Check the program.
1577 'Program type of synchronization: VEL or POS'
DETECTION During execution.
CAUSE The parameter that defines the type of synchronization in the #FOLLOW instruction
is wrong.
SOLUTION Check the program. The parameter can take the values VEL (velocity) and POS
(position).
1578 '#LINK: A UNIDIR slave axis must be of the same type as the master (UNIDIR)'
DETECTION During execution.
CAUSE The CNC has tried to activate a coupling (#LINK) with two unidirectional rotary axes
that are not identical.
SOLUTION When the axes are unidirectional, both axes must be set with the same turning
direction (parameter UNIDIR).
1579 'Home search not allowed on a master axis with several slave axes'
DETECTION During execution.
CAUSE The CNC has executed a G74 function on the master axis of a coupling with several
slaves.
SOLUTION Undo the axis coupling (slaving) and home the axes separately.
1580 '#CAX: Requires previously programming M19 in position sercos'
DETECTION During execution.
CAUSE The CNC has tried to activate a Sercos spindle as C axis without previously orienting
it with M19.
SOLUTION Program M19 before activating the spindle as C axis.
1581 'An active C axis cannot be eliminated'
DETECTION During execution.
CAUSE Instructions #SET AX and #FREE AX cannot eliminate the C axis from the
configuration if it is active.
SOLUTION Deactivate the C axis before eliminate it from the configuration.
1582 'NR: The number of repetitions has been programmed twice'
DETECTION During execution.
CAUSE The NR instruction has been programmed more than once in the same block.
SOLUTION Check the program.
1583 '#FOLLOW ON: The master and slave axes cannot be the same ones'
DETECTION During execution.
CAUSE The master and slave axes are the same axis.
SOLUTION Check the program.
1584 '#FOLLOW ON: the numerator and denominator must be integers'
DETECTION During execution.
CAUSE The numerator and/or denominator are programmed with decimals.
SOLUTION Program integers in the parameters that define the numerator and denominator of
the gear ratio.