Fagor 8065, Руководство по устранению ошибок

Страница: 112 / 220

Error solving manual.
CNC 8060
CNC 8065
·112·
(R
EF
: 1709)
2347 'PROGTL3 profile not allowed while G91 is active'
DETECTION During execution.
CAUSE A profile cannot be initiated while G91 is active and G91 cannot be programmed
inside a G841-G842 profile.
SOLUTION Program G90 before the beginning of the profile. To program incremental coordinates
inside the profiles, use the specific programming for it.
2348 'Macro G8735/G8736 defined twice'
DETECTION During execution.
CAUSE An attempt has been made to start defining a new macro without finishing the
previous one.
SOLUTION Check the program. Finish the definition of the macros correctly.
2349 'Beginning of a G841/G842 profile defined twice'
DETECTION During execution.
CAUSE An attempt has been made to start defining a new profile without finishing the previous
one.
SOLUTION Check the program. Finish the definition of the profiles correctly.
2350 'End of macro expected: G8738/G8734'
DETECTION During execution.
CAUSE The CNC has detected the end of the program without finishing the defined macro.
SOLUTION Check the program. Finish the definition of the macro correctly.
2351 'No profile has been programmed'
DETECTION During execution.
CAUSE Some profile has not been programmed in the ProGTL3 macro.
SOLUTION All the profiles must be defined in order to execute the macro correctly.
2352 'Entity not initialized'
DETECTION During execution.
CAUSE The program has attempted to use an uninitialized entity.
SOLUTION An entity must be initialized before it can be used.
2353 'Program #LSFIT [type, points]'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the program.
2354 '#LSFIT, invalid type'
DETECTION During execution.
CAUSE Parameter TYPE of the #LSFIT instruction is not valid.
SOLUTION Check the program.
2355 'Error in #LSFIT process'
DETECTION During execution.
CAUSE Generic internal error of the #LSFIT process.
SOLUTION Check the program.
2356 'Program #SELECT ORI [HEAD1-2/TABLE1-2, HEAD1-2/TABLE1-2]'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the program.
2357 'Selected rotary axes are either the same or the wrong ones'
DETECTION During execution.
CAUSE The selected two rotary axes are the same or they're wrong.
SOLUTION Check the program. The possible values for selecting the rotary axes are HEAD1,
HEAD2, TABLE1, TABLE2.
2358 '#DGWZ CYL: The programmed axis must be linear'
DETECTION During execution.
CAUSE The axis programmed in the instruction #DGWZ is not linear.
SOLUTION Select a linear axis as a longitudinal axis.