Fagor 8065, Руководство по устранению ошибок

Страница: 126 / 220

Error solving manual.
CNC 8060
CNC 8065
·126·
(R
EF
: 1709)
3061 'A master spindle that has not been homed does not admit CLOOP'
DETECTION During execution.
CAUSE The CNC cannot synchronize a master spindle in closed loop if it has not been
previously homed.
SOLUTION Home the master spindle before synchronizing the spindle.
3062 'The master spindle of the synchronization goes into open loop'
DETECTION During execution.
CAUSE The user has programmed an open-loop synchronization (OLOOP) for the master
spindle, but it was working in closed loop.
SOLUTION The CNC informs of the change; no action is required.
3063 'The master spindle of the synchronization goes into closed loop'
DETECTION During execution.
CAUSE The user has programmed an closed-loop synchronization (CLOOP) for the master
spindle, but it was working in open loop.
SOLUTION The CNC informs of the change; no action is required.
3064 'The spindle for threading in G33 must be homed'
DETECTION During execution.
CAUSE The spindle used in G33 threading has not been homed. If the CNC uses the master
spindle of the channel, it always carries out a home search before the G33. If the PLC
selects another spindle (SYNC mark), the CNC must home it.
SOLUTION Home the spindle.
3065 'The spindle speed programmed for G33 exceeds the threshold of the encoder'
DETECTION During execution.
CAUSE The speed programmed for the G33 function exceeded the threshold allowed by the
encoder installed on the spindle. Exceeding the speed threshold of the encoder
results in erroneous reading (counting) of the spindle feedback pulses.
SOLUTION The CNC does not permit executing the G33 with the programmed speed because
it cannot ensure that the validity of the thread. If the spindle has exceeded the
threshold speed, the CNC needs to home the spindle in order to recover the position
value.
3066 'Error in the way the tangential axis follows the path'
DETECTION During execution.
CAUSE The tangential axis is not faithfully following the path in the work plane.
SOLUTION Contact FAGOR.
3067 'G33/G95: 'Programming not allowed without a spindle being controlled in position'
DETECTION During execution.
CAUSE The programmed function needs a spindle controlled in position. The CNC cannot
control the spindle in position because the spindle does not have an encoder.
SOLUTION The spindle needs an encoder. Contact your supplier.
3068 'RETRACE completed, deactivate mark to continue'
DETECTION During execution.
CAUSE After ending the execution in retrace mode, the RETRACE mark of the PLC stays
active.
SOLUTION The PLC must cancel the RETRACE mark in order to resume the program.
3069 'Wrong gear change, the drive does not respond'
DETECTION During execution.
CAUSE The CNC has not completed the gear change of an axis or spindle because the drive
does not respond to the request for a gear change.
SOLUTION Check the drive status.
3070 'Zero spindle speed associated with G33/G95'
DETECTION During execution.
CAUSE The spindle associated with function G33 or G95 is stopped.
SOLUTION Check the speed of the spindle associated with these functions, that will be the master
spindle of the channel or the spindle indicated in register SYNC, associated with the
channel.