Fagor 8065, Руководство по устранению ошибок

Страница: 171 / 220

Error solving manual.
CNC 8060
CNC 8065
·171·
(R
EF
: 1709)
8041 'Memory under the minimum recommended for execution'
DETECTION During execution.
CAUSE The CNC has detected less than 50 MB of free disk memory.
SOLUTION Free disk memory is required to start up the CNC.
• Check if there is a third-party application running and consuming system
resources; if so, close it.
• Turn the CNC off and back on. If the error persists, contact the Service
Department.
8042 'Memory below recommended minimum'
DETECTION During execution.
CAUSE The CNC has detected less than 50 MB of free disk memory.
SOLUTION Free disk memory is required to start up the CNC.
• Check if there is a third-party application running and consuming system
resources; if so, close it.
• Turn the CNC off and back on. If the error persists, contact the Service
Department.
8043 'Insufficient memory to upload the file'
DETECTION During editing.
CAUSE Insufficient memory to upload the file.
SOLUTION Free memory required to upload the file.
• Check whether the CNC is executing some program or not; if so, interrupt the
execution and try uploading the program again.
• Check if there is a third-party application running and consuming system
resources; if so, close it.
• Turn the CNC off and back on. If the error persists, contact the Service
Department.
8044 'Program too large to be edited in conversational mode. Switch to standard CNC mode
to execute it or execute it'
DETECTION During editing or execution.
CAUSE The conversational program has more than 10 MB.
SOLUTION Switch to standard CNC mode to edit or execute the program'
8045 'Temporary validation code expired. Restart the CNC'
DETECTION On CNC startup or during execution.
CAUSE The CNC has detected that its temporary validation code has expired. The CNC will
not let START until the user has restarted the CNC.
SOLUTION Restart the CNC.
8046 'The temporary validation code has been canceled. Restart the CNC'
DETECTION During execution.
CAUSE The CNC has detected that the user has canceled the temporary validation code. The
CNC will not let START until the user has restarted the CNC.
SOLUTION Reset the CNC.
8047 'CNC running in UNsafe mode'
DETECTION During CNC startup.
CAUSE The CNC is running in setup mode.
SOLUTION Turn the CNC off and use the DiskMonitor utility to switch to user mode.
8048 'Incomplete setup'
DETECTION During CNC startup.
CAUSE One of the following conditions is met in user mode:
• The protection passwords have not been set.
• Backup copy missing.
SOLUTION Follow these steps to end the setup.
1. Turn the CNC off and use the DiskMonitor utility to switch to setup mode.
2. In utilities mode, go into the passwords window and enter the "general password".
3. Press [ALT][F4] to turn off CNC and select the option "Close and do a backup
copy".
4. Use the DiskMonitor utility to switch to setup mode.