Fagor 8065, Руководство по устранению ошибок

Страница: 151 / 220

Error solving manual.
CNC 8060
CNC 8065
·151·
(R
EF
: 1709)
5010 'Division by zero at the PLC'
DETECTION When executing a DVS or MDS instruction.
CAUSE The denominator of a DVS or MDS operation is 0.
SOLUTION Check the PLC program. Do not divide by 0.
5013 'Error when reading the PLC digital inputs'
DETECTION When reading the digital inputs of the PLC.
CAUSE The digital I/O configuration table is wrong.
SOLUTION Check the digital I/O configuration table. If the error persists, contact Fagor.
5014 'Error when writing the PLC digital outputs'
DETECTION When writing the digital outputs of the PLC.
CAUSE The table to set the digital I/O is wrong or the PLC has received a writing request
before finishing the previous one.
SOLUTION Check the table to set the digital I/O, runs the pertinent checks to ensure the integrity
of the CAN bus or raise the cycle time in parameter PLCFREQ. If the error persists,
contact Fagor.
5015 'The variable could not be read from the PLC'
DETECTION When executing a CNCRD instruction.
CAUSE Reading a global or local arithmetic parameter that does not exist.
SOLUTION Check the settings of global and local parameters as well as the PLC program.
5016 'Reading value out of range'
DETECTION When executing a CNCRD instruction.
CAUSE Data read out of range.
SOLUTION Check the syntax of the instruction.
5017 'Null CNCEX block'
DETECTION When executing a CNCEX instruction.
CAUSE The block programmed in the CNCEX instruction is null or the programmed channel
is not available.
SOLUTION Check the block to be executed and the status of the channel.
5018 ''CNCEX has not been executed because the communication mark is set to "1"'
DETECTION When executing a CNCEX instruction.
CAUSE The mark programmed in the CNCEX instruction is already active when executing
the instruction. It may be because the instruction has been programmed wrong or
because the channel is busy with another CNCEX instruction.
SOLUTION Check, in the PLC program, the logic of the CNCEX instruction and of the marks used.
5019 'CNCEX: Execution channel not available'
DETECTION When executing a CNCEX instruction.
CAUSE The channel programmed in the CNCEX instruction is not available. The channel is
executing another block, another program or is in a wrong state.
SOLUTION Check the status of the channel programmed in the CNCEX instruction.
5020 'CNCEX: Execution incomplete'
DETECTION When executing a CNCEX instruction.
CAUSE The CNCEX instruction cannot execute the block in the indicated channel.
SOLUTION Check the status of the channel programmed in the CNCEX instruction.
5021 'CNCEX: The indicated channel is not a PLC channel'
DETECTION When executing a CNCEX instruction.
CAUSE The channel programmed in the CNCEX instruction is not a PLC channel.
SOLUTION Check the syntax of the instruction. Check the type of channel in the machine
parameters (parameter CHTYPE).