Fagor 8065, Руководство по устранению ошибок

Страница: 76 / 220

Error solving manual.
CNC 8060
CNC 8065
·76·
(R
EF
: 1709)
1669 'Program #ROTATEMZ1-4 Pn/+n/-n'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong or there is more data in the block.
SOLUTION Check the program. Program the position to be selected on the turret or the number
of positions to rotate.
1670 'The indicated magazine must be a TURRET type'
DETECTION During execution.
CAUSE The instruction #ROTATEMZ is only valid for a turret type magazine.
SOLUTION Check the program. Verify that the magazine is a turret type.
1672 'G74-G174 not admitted for synchronized spindles'
DETECTION During execution.
CAUSE Once the spindles have been synchronized, the CNC does not allow programming
a home search or force a coordinate on any of them.
SOLUTION The CNC homes the spindles before synchronizing them. To do a home search or
force the coordinate, cancel the synchronization.
1673 'Variable that cannot be accessed by program or MDI'
DETECTION During execution.
CAUSE The programmed variable, although exists, has no permission to be accessed from
the program.
SOLUTION Check the access permissions of the variables.
1674 'Program #SELECT PROBE [probe number, POS/NEG]'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong or there is more data in the block.
SOLUTION Check the program.
1676 'The active inclined plane has been recovered'
DETECTION During execution.
CAUSE After power-up, the CNC has recovered the inclined plane that was active when
turning the CNC off.
SOLUTION The inclined plane may be deactivated with the #CS OFF instruction.
1677 '#RTCP/TLC has been deactivated'
DETECTION During execution.
CAUSE The CNC has tried to carry out a home search while function #RTCP or #TLC was
active.
SOLUTION Deactivate the #RTCP/TLC functions before searching home.
1678 'Variable only exists for external analog feedback'
DETECTION During execution.
CAUSE The programmed variable only exists for axes with external analog feedback and the
indicated axis does not meet this condition.
SOLUTION Check the program. Check the variables that may be accessed depending on the type
of axes in the manuals.
1679 '#CAM SELECT not allowed when a cam is being executed or being loaded'
DETECTION During execution.
CAUSE The CNC has requested to load a cam that is in execution or already being loaded.
SOLUTION Wait for the cam to finish execution or be loaded.
1680 'Wrong part number'
DETECTION During execution.
CAUSE A wrong part number has been programmed in the #DGWZ instruction.
SOLUTION Program the part number within the P1-P4 range.
1681 'Too many channels programmed in the instruction'
DETECTION During execution.
CAUSE More than one channel number have been programmed in the #DGWZ instruction.
SOLUTION Program a single channel number C1-C4.