Fagor 8065, Руководство по устранению ошибок

Страница: 63 / 220

Error solving manual.
CNC 8060
CNC 8065
·63·
(R
EF
: 1709)
1534 'Program: #CALLSP [sp1, sp2, ..]'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong or there is more data in the block.
SOLUTION Check the program. The instructions must be programmed alone in the block, only
the block label may be added.
1535 'Program: #SETSP [sp1, sp2, ..]'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong or there is more data in the block.
SOLUTION Check the program. The instructions must be programmed alone in the block, only
the block label may be added.
1538 'A spindle cannot be restored from the channel'
DETECTION During execution.
CAUSE A channel has released a spindle with a temporary change permission (parameter
AXISEXCH) and cannot restore it with a reset or at the beginning of a program
because the channel that took it has not released (freed) it.
SOLUTION The other channel will release the spindle with reset or with the beginning of another
program. The spindle release can also be programmed with the instruction #FREE
SP.
1539 'Spindle name repeated in the resulting group'
DETECTION During execution.
CAUSE The #RENAME instruction has tried to rename more than one spindle with the same
name.
SOLUTION Rename the spindles so there aren't two with same name in the channel.
1540 'Programming not allowed without a master spindle in the channel'
DETECTION During execution.
CAUSE The possible causes are:
• The CNC has tried to read or write a variable of the master spindle, but it does
not exist in the channel.
• The G function or instruction cannot be executed if there is no master spindle in
the channel.
SOLUTION Define a master spindle for the channel
1541 'The spindle cannot be eliminated while the C axis is active'
DETECTION During execution.
CAUSE The CNC has tried to eliminate from the channel (#FREE or #SET) a spindle that is
working as C axis.
SOLUTION Deactivate the C axis before eliminating the spindle from the channel.
1542 'The spindle cannot be exchanged'
DETECTION During execution.
CAUSE The CNC has tried to change a channel spindle (#CALL, #SET oR #FREE) and the
spindle does not have permission to change (parameter AXISEXCH).
SOLUTION In order for the CNC to be able to change the channel axes and spindles, they must
have permission. Parameter AXISEXCH sets whether the axis or the spindle has
permission to change channels and if it does, whether the change is temporary or
permanent; in other words, whether the change is maintained after an M02, M30, a
reset or after restarting the CNC.
1544 'G63 and M3/M4/M5/M19/M41-M44 not allowed in the same block'
DETECTION During execution.
CAUSE No M function associated with the spindle may be programmed in the same block that
contains a rigid tapping G63.
SOLUTION It may be programmed either in the previous or next block depending on the result
to be obtained. If programmed in the next block, these M functions cancel the modal
tapping G63 in such way that G63 must be programmed again in the next movement
in order to keep tapping.