Fagor 8065, Руководство по устранению ошибок

Страница: 180 / 220

Error solving manual.
CNC 8060
CNC 8065
·180·
(R
EF
: 1709)
8313 '#CS/#ACS: wrong coordinate system number'
DETECTION During editing.
CAUSE Invalid value for the system number in the #CS or #ACS instruction.
SOLUTION The system number must have a value between 1 and 5, both included.
8314 'G30/G73 programmed wrong'
DETECTION During editing.
CAUSE In function G30/G73 only one of parameters I or J has been programmed.
SOLUTION Program either both parameters I and J or none of them.
8315 'Wrong probe cycle number'
DETECTION During editing and execution in MDI.
CAUSE Wrong probing cycle number.
SOLUTION Refer to the documentation on valid probing cycles.
8316 'Parameter not allowed'
DETECTION During editing and execution in MDI.
CAUSE Some parameter of the cycle or instruction is not valid.
SOLUTION Refer to the programming manual to check the right parameters for each cycle and
instruction.
8317 'Negative D function'
DETECTION During editing.
CAUSE Negative tool offset.
SOLUTION The tool offset must be positive.
8318 'Only one active 1 axis allowed per block'
DETECTION During editing.
CAUSE The @1 axis has been programmed more than once in the same block.
SOLUTION Program the @1 axis only once in the block.
8319 'Only one active 2 axis allowed per block'
DETECTION During editing.
CAUSE The @2 axis has been programmed more than once in the same block.
SOLUTION Program the @2 axis only once in the block.
8320 'Only one active 3 axis allowed per block'
DETECTION During editing.
CAUSE The @3 axis has been programmed more than once in the same block.
SOLUTION Program the @3 axis only once in the block.
8321 'Only one active 4 axis allowed per block'
DETECTION During editing.
CAUSE The @4 axis has been programmed more than once in the same block.
SOLUTION Program the @4 axis only once in the block.
8322 'Only one active 5 axis allowed per block'
DETECTION During editing.
CAUSE The @5 axis has been programmed more than once in the same block.
SOLUTION Program the @5 axis only once in the block.
8323 'Comparison expected'
DETECTION During editing.
CAUSE "=" has been programmed instead of "==".
SOLUTION Program "==" instead of "=".
8324 'Tabulation not expected'
DETECTION During editing.
CAUSE There is a wrong tab.
SOLUTION Eliminate the tab.