Fagor 8065, Руководство по устранению ошибок

Страница: 170 / 220

Error solving manual.
CNC 8060
CNC 8065
·170·
(R
EF
: 1709)
8031 'The DRIVERS folder does not exist'
DETECTION During system startup.
CAUSE The CNC has not found the folder that will contain the PLC once it is generated
(C:\CNC8070\Drivers).
SOLUTION In the utilities mode, use the "new directory" option of the softkey menu to create the
folder.
8032 'The USERS folder does not exist'
DETECTION During system startup.
CAUSE The CNC has not found the user work folder (C:\CNC8070\Users).
SOLUTION In the utilities mode, use the "new directory" option of the softkey menu to create the
folder.
8034 Incomplete setup: No backup copy has been found'
DETECTION On system startup, in setup mode.
CAUSE The CNC has not found any backup copy of the setup.
SOLUTION When shutting the CNC down, select the option "close and make a backup copy" so
the CNC makes a backup copy of the setup.
8035 'The following access passwords are yet to be defined'
DETECTION When starting up an open CNC, in setup mode.
CAUSE The passwords indicated in the warning have not been defined.
SOLUTION Having powered the CNC up, access the utilities mode and from the "Passwords"
option of the softkey menu, enter the indicated passwords.
8036 'Switch to user mode or setup mode to work with the CNC'
DETECTION On system startup, in setup mode.
CAUSE It is only possible to operate the CNC in user mode and setup mode.
SOLUTION Use the DiskMonitor utility to switch to user mode or setup mode and turn the CNC
back on.
8037 'Memory below recommended minimum. It must be restarted'
DETECTION During execution.
CAUSE The CNC has detected that the available RAM memory is below 10% of the total RAM
memory.
SOLUTION Check if there is a third-party application running and consuming system resources;
if so, close it. Turn the CNC off and back on. If the error persists, contact the Service
Department.
8038 'MDI in INSPECTION not allowed in the current status'
DETECTION During editing and execution in MDI/MDA mode.
CAUSE It is not possible to get into MDI/MDA mode from the current status of tool inspection.
SOLUTION Exit tool inspection mode to get into MDI/MDA mode.
8039 'Error while loading the keyboard software'
DETECTION During CNC startup.
CAUSE Error when loading the software of the keyboard node.
SOLUTION Verify the CAN configuration, system connection and boot versions of remote nodes.
If the error persists, contact the Service Department.
8040 'Disk memory under recommended minimum for the proper operation of the CNC. Free
disk memory before starting the CNC up'
DETECTION During CNC startup.
CAUSE The CNC has detected less than 50 MB of free disk memory.
SOLUTION Free disk memory is required to start up the CNC.
• Check if there is a third-party application running and consuming system
resources; if so, close it.
• Turn the CNC off and back on. If the error persists, contact the Service
Department.