Fagor 8065, Руководство по устранению ошибок

Страница: 121 / 220

Error solving manual.
CNC 8060
CNC 8065
·121·
(R
EF
: 1709)
3000-3999
3000 'An arc cannot be programmed with a slave axis'
DETECTION During execution.
CAUSE The CNC tries to individually move the slave axis of a coupling or of a gantry axis.
SOLUTION A slave axis cannot move separately. To move a slave axis, move the master axis it
is associated with.
3001 'An axis cannot be moved in DRO mode'
DETECTION During execution.
CAUSE The CNC tries to move an axis that is in DRO mode.
SOLUTION The CNC cannot move the axes that are active in DRO mode. To move the axis, cancel
the DRO mode [PLC mark DRO(axis)].
3002 'Positive software travel limit overrun'
DETECTION While repositioning an axis.
CAUSE During the repositioning movement, the axis has reached the software travel limits.
If the repositioning point is beyond the software travel limits, the axis cannot reach
that point.
SOLUTION The axes must always be within the software limits. Check that the software limits are
correct, that they have not been modified via part-program or by PLC.
3003 'Negative software travel limit overrun'
DETECTION While repositioning an axis.
CAUSE During the repositioning movement, the axis has reached the software travel limits.
If the repositioning point is beyond the software travel limits, the axis cannot reach
that point.
SOLUTION The axes must always be within the software limits. Check that the software limits are
correct, that they have not been modified via part-program or by PLC.
3005 'Error of the position control when initializing the probing process'
DETECTION When initializing the probing process.
CAUSE It is an enabling safety feature of the probing process. An axis has been programmed
that is not valid or is not available.
SOLUTION Check that the programmed axes are valid and available.
3007 'The probe signal has been received before the movement'
DETECTION After detecting the probe signal.
CAUSE Probing process enabled without having programmed G100.
SOLUTION Contact your supplier.
3008 'Error in the probing process'
DETECTION After detecting the probe signal.
CAUSE It is an enabling safety feature of the probing process.
SOLUTION Check that the programmed axes are valid and available.
3010 'The axis has not been defined as probe (PROBEAXIS)'
DETECTION During execution.
CAUSE A probing movement has been programmed on an axis that is not defined as an axis
involved in the probing movement.
SOLUTION Parameter PROBEAXIS determines whether the axis can participate in probing
movements or not.