Fagor 8065, Руководство по устранению ошибок

Страница: 91 / 220

Error solving manual.
CNC 8060
CNC 8065
·91·
(R
EF
: 1709)
1841 'Wrong tool position before the canned cycle'
DETECTION During the execution of the cycle.
CAUSE When executing the canned cycle, the tool tip is located between the reference plane
and the surface of the part.
SOLUTION To execute the cycle, position the tool above the reference plane.
1842 'Tool diameter smaller than DELTA'
DETECTION During the execution of the cycle.
CAUSE The finishing tool diameter is smaller than the milling pass (parameter

).
SOLUTION Reduce the milling pass or use a tool with a larger diameter.
1843 'Pocket with islands: Wrong roughing tool radius'
DETECTION During the execution of the cycle.
CAUSE The roughing tool radius is 0 or the tool is too large for the geometry of the pocket
considering the lateral stock (parameter

).
SOLUTION Correct the value of the tool radius in the tool table or select another tool. Check the
value of the lateral residual stock.
1844 'Pocket with islands: Wrong finishing tool radius'
DETECTION During the execution of the cycle.
CAUSE The finishing tool radius is 0 or the tool is too large for the geometry of the pocket.
SOLUTION Correct the value of the tool radius in the tool table or select another tool.
1845 'G165: Chord length (I) greater than the diameter'
DETECTION During the execution of a multiple machining cycle.
CAUSE The length of the chord (parameter I) is greater than the diameter of the circle.
SOLUTION Assign a correct value to the parameter.
1846 'Zero arc radius'
DETECTION During the execution of a multiple machining cycle.
CAUSE The possible causes are:
• There is an arc with zero radius in the profile.
• In a multiple machining operation in an arc or a circle, both center coordinates
are the same as the those of the starting point.
SOLUTION Check the program.
1847 'RECTANGULAR BOSS: Q = 0'
DETECTION During the execution of the cycle.
CAUSE The value of parameter Q (stock to be removed) is 0.
SOLUTION Assign a value other than 0 to the parameter.
1848 'CIRCULAR BOSS: Q = 0'
DETECTION During the execution of the cycle.
CAUSE The value of parameter Q (stock to be removed) is 0.
SOLUTION Assign a value other than 0 to the parameter.
1849 'RECTANGULAR POCKET: Finishing stock DELTA greater than the pocket'
DETECTION During the execution of the cycle.
CAUSE The size of the pocket minus the tool diameter is smaller than the lateral residual stock
(twice parameter

).
SOLUTION Assign a correct value to the parameter.
1850 'Lx must be multiple of Ix'
DETECTION During the execution of a multiple machining cycle.
CAUSE The length of the machining operation (parameter Lx) must be multiple of the step
between machining operations (parameter Ix).
SOLUTION Assign a correct value to the parameters.
1851 'Ly must be multiple of Iy'
DETECTION During the execution of a multiple machining cycle.
CAUSE The length of the machining operation (parameter Ly) must be multiple of the step
between machining operations (parameter Iy).
SOLUTION Assign a correct value to the parameters.