EMS Operation
SkyView Pilot’s User Guide - Revision M
5-11
When a circuit is selected the menu at the bottom of the SkyView screen automatically changes
to allow control of the circuit.
All Circuits
RESET button: Press this button to reset any circuit that has a fault condition that the
VP-X will allow to be reset. This button will be grayed out and unavailable if the circuit is
not in a fault condition.
Flaps and Trim Circuit Controls
UP and DOWN buttons:
o
For Elevator Trim: Moves the elevator trim up or down as described in the VP-X
documentation. This button can be held down for continuous trim movement.
o
For Flaps: Moves flaps up or down as described in the VP-X documentation.
Depending on the VP-X configuration, a single quick press of the UP or DOWN
button may move the flaps to a preconfigured angle or notch of flaps. Or, it may
only move the flaps momentarily. This button can be held down for continuous
trim movement.
LEFT/RIGHT buttons
o
For Roll Trim: Moves the roll trim left or right as described in the VP-X
documentation. This button can be held down for continuous trim movement.
Power Circuits
ON and OFF buttons: Press these buttons to turn a circuit or device on or off on
demand. These buttons are not available if the circuit is in a fault condition. ON and OFF
override the physical VP-X switch for the circuit (if configured) until the relevant VP-X
physical switch is toggled.