DAP Technology 1394, Руководство по эксплуатации

Страница: 52 / 458

Commander
52 Copyright © DapTechnology B.V., 2005-2019 - All Rights Reserved., 5/20/2019
Active Configuration Rom and Bus_Manager_ID reads
If Configuration-Rom information of some node or the Bus_Manager_ID register value is needed, the
Analyzer will read it actively. It will only use quadlet read transactions.
If the ‘node display options’ that are retrieved from the Bus_Info_Block are all disabled and if the ‘Bus and
node information’ button is not pressed, the Analyzer will not generate any active transactions.
If one or more ‘node display options’ are enabled that need to be retrieved from the Bus_Info_Block or if
the ‘Bus and node information’ button is pressed and a node is selected, then the Configuration Rom of
one or more nodes will be read when needed.
If the ‘Bus and node information’ button is pressed, the Bus_Manager_ID register will be read too when
needed.
6.2.2. Memory R/W
The 'Memory R/W' page consists of the following parts:
· address specification
·
length specification
· read/write/lock control
· data table
address specification
The read/write and lock start address can be specified by specifying the bus, node and offset.
local
If the 'local' checkbox below the 'Bus' box is checked, the bus number will be fixed to 1023, which is the
number used to identify local busses. Otherwise, you can fill in a decimal number in the 'Bus' box.
Bus
If 'local' is not checked, you can fill in a decimal bus number here. The range is from 0 to 1022.
broadcast
If the 'broadcast' checkbox below the 'Node' box is checked, the node number will be fixed to 63, which is
the number used to identify broadcast transmissions.