DAP Technology 1394, Руководство по эксплуатации

Страница: 222 / 458

Filter/Trigger
222 Copyright © DapTechnology B.V., 2005-2019 - All Rights Reserved., 5/20/2019
ended because of the detection of Packet or Acknowledge, then the result of the
jump-condition is always false. The three elipses indicate that additional sub-selections are
possible. When selecting this option, the additional sub-selection options appear at the right
top of the Jump Properties box. See example below.
The following sub-selections are possible:
·
Any Event: If this option is selected, the jump-condition will be true for every event that
is detected.
·
Event ...: If this option is selected, additional check boxes appear where you can specify
one or more events. If an event was detected for which the corresponding checkbox is
checked, the jump-condition is true.
In the example above, the jump-condition is only true for a BusReset Event.
At the bottom of the Jump Properties page you can select if the jump should be taken if the
specified jump-condition is true (radio button Y: Jump if condition met) or if the
jump-condition is false (radio button N: Jump if condition not met).
The letter 'Y' or 'N' drawn on the jump line left or right of the Jump item (in the flow diagram)
indicates this selection.
· Action Properties: Using this properties page you can select the actions to be performed