Avaya WLAN 8100 Series, Справочник, Страница: 147 / 382

Displaying interfaces on page 150
Configuring Interface Options on page 151
Enabling Jumbo Frames on page 151
Configuring the EDM Help File Path on page 151
Configuring the HTTP Port on page 152
Setting port speed on page 152
Testing cables with the Time Domain Reflectometer on page 154
Enabling Autotopology on page 155
Enabling flow control on page 156
Enabling rate-limiting on page 158
Assigning and clearing IP addresses
You can assign, clear, and view IP addresses and gateway addresses with CLI. The
commands discussed in this section are used to perform these tasks.
Note:
Users should not change the Wireless System IP address of the controller after the controller
joins a domain. Do the following if a change is required after the controller joins a domain:
1. Remove the controller from the mobility domain.
2. Disable wireless operations.
3. Change the IP address.
4. Join the controller to the domain.
ip address command
The ip address command sets the IP address and subnet mask for the switch.
This command is executed in the Global Configuration command mode.
CLI reference:
WCP8180(config)#ip address ?
A.B.C.D IP address
netmask The subnet mask
source BootP/DHCP mode
The following table describes the parameters for the
ip address
command.
Table 5: ip address parameters
Parameters Description
A.B.C.D Denotes the IP address in dotted-decimal notation; netmask
is optional.
netmask Signifies the IP subnet mask.
source BootP/DHCP mode
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference August 2013 147