Chapter 4 Unpacking and Inspecting
Installation and Commissioning Manual
107
F
S
P
3000R
7 R
11
.1 8000
0015930
Issue
B
, ©
2012
ADVA AG Optical Netw
orking
ADVA Conf
idential
Step 7
If any item is missing, or if any item is damaged, notify your customer
service representative or ADVA Optical Networking immediately.
End of Procedure
Unpacking an FSP 3000R7
ROADM-C40/40/2-3HU-2DC Shelf
This section describes how to unpack the ROADM-C40/40/2-3HU-2DC Shelf.
Each shelf shipment contains one ROADM-C40/40/2-3HU-2DC chassis, an
installation kit and fiber jumper labels.
Tools Required
You need utility scissors or a utility knife to open the cardboard box.
Procedure
To unpack a ROADM-C40/40/2-3HU-2DC Shelf perform the following steps:
Step 1
Move the cardboard box with the ROADM-C40/40/2-3HU-2DC Shelf
to the location where the shelf will be installed.
Step 2
Open the cardboard box on the upper side only as follows:
a) Using a utility knife or scissors, cut open the adhesive tape. Pay
attention not to damage the flaps.
b) Lift the flaps toward you so that the box is opened completely.
Step 3
Remove everything from the cardboard box.
P
S
Note
Do not destroy or discard the cardboard box. Flatten and save it along
with the packaging material. This way you can transport a shelf safely
or, if necessary, return it to the factory for repair.
CAUTION
Only Service Personnel are allowed to unpack a
ROADM-C40/40/2-3HU-2DC shelf.
P
S
Note
Review the guidelines provided in
before you
open the shipping box and unpack a ROADM-C40/40/2-3HU-2DC
shelf.