5-5
5
IM 701830-01E
Vertical and Horizontal Axes
5.4
Setting the Vertical Position of a Waveform
(For High-Speed Isolation/High-Speed/High-Resolution, High-Voltage, Isolation/High-
Resolution, Isolation/Logic Input Modules)
≡
For a description of this function, refer to page 1-4.
≡
Function
Range of movement
The vertical position can be moved in the range between
±
4 div from the center position in the
waveform display frame.
Setting resolution
0.01 div
Waveforms that can not be moved
Snap shot waveforms
Confirming the vertical position
For input waveforms and computed waveforms, the ground level and vertical position are
marked on the left of the waveform display frame.
500mV/div,Offset : -1V,Position:0div
Ground level
mark
Vertical position
mark
Note
• The data which go out of the waveform display frame from moving the vertical position are handled as
overflow data.
• If the display waveform goes out of the waveform display frame from moving the vertical position
during the waveform acquisition is starting, a chopped waveform is displayed as shown in the following
figure even if the vertical position is returned to its original position after stopping the acquisition.
Operating Procedure
1.
Press one of the keys
CH1
to
CH16
to select the desired channel. To select the optional 32-
bit extended logic input (/N1), press the
SHIFT
key and then either the
CH1
key (LOGIC1)
or the
CH2
key (LOGIC2).
2.
Press the “
Position
” soft key to set the jog shuttle action to “
Position
”.
3.
Turn the jog shuttle to set the vertical position.
You can change the setting a digit using the arrow keys (located below the jog shuttle).
