9-2
IM 701830-01E
Marker jump to the original waveform display frame: Marker Jump
Sometimes the marker cursor goes out of the waveform display frame when the waveform is
being zoomed or when the display record length is shorter than the set record length. In such
case, this allows the marker cursor to jump to the center of the waveform display frame. The
operating procedure is explained below.
M1 to Z1
: Jump Cursor1 to the center of the Z1 zoom waveform display frame
M1 to Z2
: Jump Cursor1 to the center of the Z2 zoom waveform display frame
M2 to Z1
: Jump Cursor2 to the center of the Z1 zoom waveform display frame
M2 to Z2
: Jump Cursor2 to the center of the Z2 zoom waveform display frame
M1 to Main : Jump Cursor1 to the center of the waveform display frame
M2 to Main : Jump Cursor2 to the center of the waveform display frame
Points for attention during cursor measurement
• Horizontal axis values are measured from the trigger position (excludes user defined cursors.)
• “***” will be displayed if measurement is impossible.
• Measured values can be displayed in the extra window. For details refer to page 8-7.
• When the marker cursor is outside the waveform display frame, only the horizontal axis
value is displayed.
• If the logic waveform (Logic Input Module) or simultaneous binary computation of all
channels waveform is being measured with the cursor, the values are displayed as follows.
Marker cursor : Displays “***” for the vertical axis value.
H cursor
: Displays “***”.
V cursor
: Displays binary values with the MSB set to CH1 and the LSB set to CH16
(waveforms of simultaneous binary computation of all channels).
Displays the binary values with the MSB set to bit8 of POD B and the LSB
set to bit1 of POD A (logic waveform).
Cursor measurement is invalid for user defined cursors and when displaying X-Y waveform.
Operating Procedure
Selecting the cursor type
1.
Press the
CURSOR
key.
2.
Press the “
Type
” soft key to display the cursor type menu.
3.
Keep pressing the “
Type
” soft key to select the desired cursor type.
Selecting the waveform source
4.
Press the “
Cursor1 Trace
” soft key to display the channel select menu.
5.
Turn the jog shuttle to select the channel.
Channels which do not have input modules installed are not displayed on the menu.
6.
If “
Marker
” has been selected as the cursor type, press the “
Cursor2 Trace
” soft key to
select the desired waveform source.
→
9.1 Measuring Waveforms using Cursors
