10-2
IM 701830-01E
Operating Procedure
While pressing the lock release lever towards
“OPEN” lift the handle on the left of the printer cover
and open the cover.
Move the release arm, located on the right near the
front, to the “MAN FEED” position.
Have the inner side of the roll paper (the side that is
not glossy) showing on top for the following
procedure. While pressing the movable holder,
located on the left of the roll chart storage space, to
the left, set the core of the roll paper to the holder on
the right. Then, release the movable holder.
Insert the edge of the roll paper evenly in the space
between the roller and the black guide, then rotate the
paper feed knob away from you until about 10 cm of
the roll sheet is showing from the top of the roller.
Move the release arm to the “FREE” position and
straighten out the roll sheet. Then, move the release
arm to the “HOLD” position.
The printing will fail with an error message, if the
release arm is in the “FREE” or “MAN FEED”
position during operation.
Pull the printer cover back to its original position and
close the cover. Make sure that the edge of the roll
sheet is showing from the opening of the printer
cover.
Push the printer cover down firmly until it clicks into
place.
Note
After installing the roll chart, make sure that the chart is feeding properly according to the steps given on
the next page. If the roll chart does not feed straight, continue to feed the paper for about 30 cm. It should
straighten itself out.
10.1 Loading Paper Roll in Printer
Printer cover
Handle
Lock release lever
Release arm
Movable holder
MAN FEED
Rotate the paper
feed knob
Roll paper
Release arm
Guide
Roller
FREE
HOLD
