5-1
5
IM 701830-01E
Vertical and Horizontal Axes
5.1
Turning Channels ON/OFF
Function
The channels CH1 to CH8 can be displayed simultaneously.
For channels which have their display is turned ON, the LED above the key lights.
However, channels which do not have input modules installed cannot be turned ON.
Note
• The screen can be split into up to eight display areas. (Refer to page 8-1.) A scaling value and
waveform label name for each display area (refer to page 8-8, 8-9) can also be displayed.
• If a waveform or waveforms are loaded from history memory or floppy disk, the input waveform cannot
be displayed. To compare waveforms, use the snapshot function.
Operating Procedure
1.
Press one of the
CH1
to
CH16
keys to select the desired channel. To select the optional 32-
bit extended logic input (/N1), press the
SHIFT
key and then either the
CH1
key (LOGIC1)
or the
CH2
key (LOGIC2).
2.
Press the “
Display
” soft key to select “
ON
” or “
OFF
”.
The display can be turned ON/OFF directly by pressing
CH1
to
CH16
several times.
Note
The ON/OFF of the display of each channel can be set using the jog shuttle and the
SELECT
key when the
power is turned ON; immediately after performing initialization or auto set-up; when the saved data is
loaded; or at the screen displayed after continuously pressing the
ESC
key (all channel setting menu).
Refer to page 5-15.
Chapter 5
Vertical and Horizontal Axes
