YOKOGAWA DL716, User Manual

Page: 65 / 255

4-5
4
IM 701830-01E
Common Operations
Settings made by auto set-up
Waveform acquisition and display
Acquisition mode Normal
Acquisition count Infinite
Record length 1 kword
Accumulation mode OFF
Zoomed waveforms Traces set ON for display (realtime OFF)
Vertical-axis settings
V/div Set so that amplitude is between 2 divp-p and 7 divp-p
(approximately)
Offset voltage At Center 0 V : 0 V
At Center Offset : Center value of the maximum and minimum
values of the input signal
Vertical position 0div
Coupling DC
Inverse display OFF
Display ON/OFF If “All” channels are selected, only channels with active input signals
are set ON for display. If a single channel is selected, only that
channel is set ON for display.
Horizontal-axis settings
T/div Set so that screen displays 2 to 4 periods of the auto-setup waveform
with the longest period.
Time Base Set the time base to “Int.”
Trigger settings
Trigger type SIMPLE
Trigger source The auto-setup channel with the longest period (if “All” channels are
selected), or the target channel (if a single channel is selected).
Trigger level and slope Level is 1/2 the trigger source amplitude. Slope is “rising.”
Trigger coupling DC
Hysteresis (High sensitivity)
Holdoff time 0ns
Trigger position 50%
Trigger delay 0s
Automatic setup affects only the settings listed above. All other settings remain unchanged.
Note
• Auto-setup is not applied to channels whose input signals do not meet the required setup conditions.
Following auto-setup, display for these channels will be set OFF (even if an input signal is present.)
• If auto-setup cannot execute on all channels, the trigger source is set to CH1.
Operating Procedure
Selecting the center position and channel and performing auto set-up
1.
Press the
SETUP
key. The set up menu will appear.
2. Press the “ Auto Setup Center ” soft key to select “ 0V ” or “ Offset ”.
3. Press the “ Auto Setup ” soft key to display the channel selection menu.
4. Select the desired channel (ALL, or CH1-CH16) using the jog shuttle.
“
CH1 ” to “ CH16 ” can be directly selected by pressing
CH1
to
CH16
.
5. Press the “ Auto Setup ” soft key to start auto set-up.
Canceling auto set-up
6.
Press the “ Undo ” soft key. This will restore the previous state which was in effect before
the auto set-up.
4.3 The Auto Set-up Function