Xante ScreenWriter 3, Manual

Page: 52 / 288

3-16 Macintosh Setup bb ____________________________________
Note: If your printer has two cassette trays, select
Upper Optional Tray: Installed. If it has three
cassettes, select Upper Optional Tray: Installed
and Lower Optional Tray: Installed.
b. Select True for Spooler Enabled to activate the Save
Spooled Job menu in your application Print dialog box if
your system has an optional internal hard disk.
Note: This does not enable the Spooler on your printer.
The Spooler must be enabled using either the front
panel Interface menus or XANTÉ Command
Center. See “Spooler” in chapter 6 and “Spooler”
later in this chapter for details.
c. Select the amount of RAM installed on your printer.
8. Click OK twice. The Chooser window reappears. Then, close
this window.
Note: When you add a printer from the network, go through either
the Auto Setup or manual setup procedure to ensure that the
printer is recognized by the network.
Configuring the Printer
If necessary, configure the printer’s communication interface using
the front panel. See Chapter 6, “Configuration,” for details.
1. Select the
SETUP:I/F
menu.
2. Select the menu for the printer interface connected to your
computer (
LTALK
or
ETALK
).
3. Select the
ENABLE
menu. Then, choose
YES
.
4. Press the Reset key until
READY/IDLE
appears.