Xante ScreenWriter 3, Manual

Page: 252 / 288

10-16 Options bb __________________________________________
3. Remove the interface bracket from the printer using the
following procedure (fig. 10.12).
Fig. 10.12 Remove the Interface Bracket
a. Remove the two bracket screws with the Phillips
screwdriver.
b. Remove the hex nuts on each side of the serial port.
c. Carefully pull the bracket off the printer. You may have
to squeeze the parallel connector locks together as you
pull the bracket off.
4. Replace the blank Ethernet access panel with the Ethernet
interface panel (fig. 10.10) using a Phillips screwdriver.
5. Align the pins on the Ethernet board over the connectors on the
controller board with the 10Base2 and 10BaseT connectors at
the edge of the board; then press the Ethernet board onto the
controller board.
Note: To align the board easily, look at the Ethernet board
and the controller board through the opening left by
the interface bracket (fig. 10.13).