Xante ScreenWriter 3, Manual

Page: 226 / 288

9-4 Maintenance and Specifications bb ________________________
• Allow the printer side vent at least 8.0" (200 mm) clearance to
prevent overheating. Never insert anything into the vent.
• Make sure the output tray does not overfill. Overfilling can block
media as it comes out and cause a printer jam.
• Check the power cord and plug monthly and replace it
immediately if you find any damage.
Storing the Printer
Use the following procedure when storing the printer for an extended
period.
1. Turn off the printer. Unplug the power cord from the power
source.
2. Remove all media from the multipurpose feeder. Close the
multipurpose feeder and, if necessary, the top cover. See
chapter 2 for instructions.
3. Store the printer and media properly.
a. Store the printer and media in an area with a temperature
of 32˚ to 95˚ F (0˚ to 35˚ C) and a relative humidity of
15% to 80% with no condensation.
b. Store the printer and the media in the original containers
or cover them to protect from dust.
Moving the Printer
Use the following procedure when moving the printer.
Warning! The printer weighs approximately 58.5 lbs (26.5 kg)
without the toner, cassettes, and media installed.
• Always have two people lift the printer.
• Only lift the printer using the recessed grip areas on
the right and left sides.