Xante ScreenWriter 3, Manual

Page: 166 / 288

5-28 Ethernet Setup bb ______________________________________
Windows NT 4.X Configuration
Windows NT is a cross platform networking system. This section
describes configuring the printer’s Ethernet interface for TCP/IP or
EtherTalk protocols on a system running Windows NT 4.X.
LPR Port Setup for TCP/IP
After completing the driver installation, use the following procedure
to configure your printer for Windows NT 4.X network printing.
1. Make sure that the TCP/IP address has been setup on your
printer for your network and that you can PING this address
from your PC. If not, see “TCP/IP Addresses” and “Set the
TCP/IP Address” earlier in this chapter for details and check
with your System Administrator.
2. Click Start: Settings: Printers. Then, right click on the new
XANTÉ icon and select Properties.
3. Click the Ports Tab; then, click Add Port. The Printer Ports
window appears (fig. 5.23).
Fig. 5.23 Printer Ports Window